@d-healey sorted, thank you!

@mjc123 Exactly what i'm after, thank you!

@d-healey Thanks for your help!! I want to control each step with a respective button (which toggles between 0% and 100% value on the step.

Is this possible? If so - if you could point me in the right direction that would be very helpful!

@dannytaurus Thank you for the guidance! I'll give it a go :)

Say i have an animation that is looping constantly, linked to a time-based modulator such as an LFO.

Can I link them together so that the animation speed/loop speed (no. of frames per second) increases in line with the LFO's speed/rate?

And should I use being using lottie for this purpose or stick to usual HISE animations?

Bit new to this still, thanks for your help!

Hi, I am trying to create an animation for my LFO effect plugin. I am using the table to control a shape, which can be applied to various modulators like volume, low pass filter etc.

However I need to figure out a way to create a smoother version of the 'moving line' indicating the current X-axis value on the table. See video below to see what I mean. It just appears slightly block-y at the moment and I want to create a new version that is smoother.

What's my best bet, should I be using Lottie animations/strips for this? Can I link it up with the rate if so?

Hopefully that makes sense!

CleanShot 2025-08-24 at 22.11.35.mov

Hey, random question...

Is it possible to control specific steps on the step modulator with UI controls?

I want to give each step (32 in total) a button each which allows the user to switch the step level from 0.00 to 1.00 for each step.

Is this at all possible?

Thanks :)

Any suggestions on best method for creating a knob that controls 'NumSteps' on the step modulator, that works in a non-linear fashion? So rather than 1,2,3,4,5,6 etc, the options are 1, 2, 4, 8, 16, 32

Thank you

@d-healey thank you!

Hey, sorry if this is an obvious solution (hopefully it is)

In presentation mode I can't seem to drag any knobs on my UI. It originally worked but now seems to have fallen back into a mode where you have to type in the % value to adjust the knob (value is shown in small lettering, as seen in the attached screenshot)

How do I change this back so I can physically drag the knob while in presentation mode?

Thank you!

@d-healey sorted, thank you!