Scriptnode Compilation problems

[MysticForgeRider]

Hi guys!

As the title suggests: I can't figure out why, but within HISE, my scriptnode network works perfectly fine, and better than expected, but when I open it up in Ableton, the scriptnode seems to be silent. Other modules work fine (volume or saturation).

Maybe it's something in my scriptnode? Any extra definitions need to be set maybe?

Thanks!

[Lindon]

@MysticForgeRider you have A LOT of params (21 I count) which may well be one of your problems, did you compile this scriptNode network to a dll?

[ustk]

@MysticForgeRider I'd add that you shouldn't have warnings on the top right of the parameters. Click on them to correct the range.

Except for some exceptions like bypass_node, unscaled_nodes, etc... (which for shouldn't be the case @Christoph-Hart. A warning means something's off, so they should be removed for those special cases...)

[MysticForgeRider]

@MysticForgeRider Yup, all needed to control the paths. It is what it is!
The compiling to DLL doesn't work with my system for some reason, but I've found a workaround.

[MysticForgeRider]

@Lindon Correct, but, the parameters work as expected, and even after correcting the suggested range, it still shows the warning.

[Lindon]

@MysticForgeRider said in Scriptnode Compilation problems:

The compiling to DLL doesn't work with my system for some reason, but I've found a workaround.

you are going to need this to work.

[MysticForgeRider]

@Lindon if you can point me in the right direction ;)

https://forum.hise.audio/topic/14178/compile-network-as-dll-instant-crash/32?_=1768813567918

[Lindon]

@MysticForgeRider

start with a really simple ScriptNode network in a really simple project....and see what happens.

[MysticForgeRider]

@Lindon like already mentioned in that thread: done..

[HISEnberg]

@MysticForgeRider Maybe share the scriptnode network? That way you can at least isolate if it is a problem with the network or a configuration with your HISE setup not related to network.