Develop branch cannot support more than 19 scripts

[d.healey]

@lindon Click on the call stack tab, bottom right, and you can go back through the call history to hopefully see where this issue is starting from.

[Lindon]

@d-healey right did that and it shows me this:

[d.healey]

@lindon Does clicking through that list reveal anything useful to you?

[Lindon]

@d-healey no.

[d.healey]

@lindon Then I'd go back to the commenting out lines of code technique. If you want to send the project to me I could take a look at it and see if I can spot anything.

[ustk]

@Lindon Seeing the result, this might be related to a sampler that does wrong audio/buffer access since it seems related to audio write/read lock issue.
Try bypassing your samplers might reveal the culprit

[d.healey]

@ustk said in Develop branch cannot support more than 19 scripts:

Try bypassing your samplers might reveal the culprit

You'd need to do that by editing the xml since you can't open the project.

[Lindon]

@d-healey The problem here is made a LOT worse because sometimes it will load and most times it wont.. so I:

• remove a block of code - it loads, I put it back - it works - I remove it again- it works, I add it back again - it fails...

@ustk - I've commented out the sampler loading - that isnt fixing it. sadly.

[d.healey]

@lindon Send it over and I'll see if I can debug it, at this point we're all just poking around in the dark.

[ustk]

@lindon Then someone has to review the code in question, something inside is probably causing instability (huge loops, timers, etc...)
EDIT @d-healey have spoken...

[Lindon]

@ustk said in Develop branch cannot support more than 19 scripts:

@lindon Then someone has to review the code in question, something inside is probably causing instability (huge loops, timers, etc...)
EDIT @d-healey have spoken...

Well you'd think so but.....

I just commented out every single line of code in the whole product...

and still it crashes on load.

[Lindon]

@Christoph-Hart - can from time to time get it to load - if I wait after starting HISE for about ten seconds and then try loading the project -- which is starting to make me think its not a problem in my code at all... its a bug in Develop....

[d.healey]

@lindon Send me the project

[Lindon]

@d-healey OK will do.

[Lindon]

@d-healey - meanwhile can you send me a Win 10 build of develop so we can see if its the way I've built mine....?

[d.healey]

@lindon Good thinking. Here ya go - https://www.dropbox.com/s/4zlgrjqjkfya7jh/HISE.exe?dl=0

[Lindon]

@d-healey - OK well "good " news there - its crashing in the same way as my version of HISE....

[d.healey]

@lindon Have you tested on MacOS?

[Lindon]

@d-healey not yet.

[d.healey]

@lindon Good news (sort of) is I get an instant crash too (on Debian). Now to debug :)