ScriptNodeFX Splitting L/R signals help please?
-
This is my chain. The thing im not getting is why im getting "Ch.1" twice as opposed to "Ch.1" for the left and "Ch.2" for the right. (See below). I have a routing matrix before the 'multi container' to make sure there is a stereo pair coming through and one after it. How come within the multi container, which is supposed to split the signals into separate mono signals, just duplicates "Ch.1". Please help if you can! See below for my current setup. Tell me what im doing wrong.
-
@Chazrox It doesn't mean ch1 per say, it's just that it's the 1st (and unique) channel in THIS node. So if you have pultiple single channel nodes, they're all ch1 despite they treat channels 1,2,3,etc... globally. All is good
-
@ustk Ahhh. ok, Thanks. So whats making me think something weird is going on also is that When I try to pan each channel, it doesn't seem to be panning. Im trying to make my own stereo delay with the option to pan from center outwards.
-
@Chazrox Check out the mid/side node for doing that. The pan node is basically just two gains applied to each channel and it will just make the left or right channel quieter/louder. It doesn't actually send the signal from left to right.
-
-
@ustk Sweet! Thank You!
If I can ask one more question. Im trying to figure out how to convert ms/beat divisions. I was going through the converter.node options and I cant see how to do that.
-
@HISEnberg That makes sense. Thanks. I was wondering why there is a LR/MS conversions but not Stereo/Mono.
-
@ustk When I put turn the "Widen" knob up (mono/stereo) Im getting a bit-crushy sound in the stereo field. If I dial the "Widen" knob down to (mono) its fine and the signal is nice and mono. Any clue why im getting the weird noise on the outsides? I changed my delay setup to the way you have yours. I just need it to be within a Wet/Dry mix chain also.
I love how its actually going from mono to stereo now. I can use this in a lot of situations. I just cant find that noise. I was reading in docs how send and recieve nodes should be of the same sample rate but I also cant see where to check that. Its not in the parameters popup window.
Docs on 'Send' and 'Recieve' nodes: