ScriptNode Band Splitters - Control Frequencies?

DanH

I'm just trying out the pre-made Band Spitters in Scriptnode and for some reason when I compile the network I can't change the crossover frequencies - the controls do nothing. Before compiling it works fine.

Any ideas?

griffinboy

@DanH

Oh, that's been an issue for a while (over a year). I've been using c++ splitters instead, I'll post them here

griffinboy

@griffinboy

https://1drv.ms/u/c/6c19b197e5968b36/ESv7Pm8TL7FDqO6I521nz4UBp-jlUb6w0fVZpwXutzk_aA?e=zho87t

C++ Multiband split.

These filters *may" have some latency (linear phase). But I haven't checked yet to see if that's true.
(Should be easy to check just run two sine generators at once: one with Multiband splitters on it, one without. Then check for phase cancellation between the two sines)

DanH

@griffinboy Thanks. Do you have any without latency?!

griffinboy

@DanH

I'm not sure if it's possible without latency if you want the bands to sum perfectly. Maybe if using convolution / FIR?

You can try measure the latency of the filters I've not actually tested it, I assume there to be additional latency but I may have been mistaken.

DanH

@griffinboy cool I'll give them a whirl

Lindon

@DanH said in ScriptNode Band Splitters - Control Frequencies?:

I'm just trying out the pre-made Band Spitters in Scriptnode and for some reason when I compile the network I can't change the crossover frequencies - the controls do nothing. Before compiling it works fine.

Any ideas?

what do you mean by "Band Splitter" ? you mean the multiband filters LWR?