send effect only goes to channels 1 and 2? ... how do I have a reverb send to all channels?
-
still, all 4 channels of my instrument output to 1 stereo pair for final ouput.
Seems like i could just route each mic channel of my instrument to the reverb send...like you in a DAW or mixer?
-
@jeffd said in send effect only goes to channels 1 and 2? ... how do I have a reverb send to all channels?:
still, all 4 channels of my instrument output to 1 stereo pair for final ouput.
Why not mix the samples to stereo before putting them in the instrument? It will save some RAM, CPU, and disk space.
-
I have a 4 channel mic mixer that mixes 4 different stereo pairs. I want to add a reverb send to those channels. all those channels mix to stereo for the final output, but HISE only sends reverb to the first pair. I really need to make 4 different reverbs?
-
i think i must be missing them very obvious
-
@jeffd said in send effect only goes to channels 1 and 2? ... how do I have a reverb send to all channels?:
I really need to make 4 different reverbs?
If you want different reverb for each pair then yes. If you want the same reverb for all channels then you can probably achieve that using a routing matrix.
But why do you have the mic mixer if you're just outputting stereo in the end?
-
@d-healey I have the instrument setup so you can mix 4 different mic signals, then that gets routed out stereo. I have 4 simple gain slots under 1 sampler. But the send container only routes to the first simple gain effect basically, or that first channel. I want the same reverb for all channels.
-
I just did a little test. If you put the send effect at the container level, and the container is only stereo, it gives the desired result.
-
@d-healey
ok, so i have my sampler1 outputting 8 channels to 8 channels in on container1.I changed that so its outputting the 8 channels from sampler1 to 2 stereo out into Container1.
but now my reverb is feedbacking like crazy
-
@jeffd
i think now im experiencing this
Send Effect make Nasty Feedback ( Almost Death )
Hey Folks, Is Send effect broken or Am I Doing some Wrong moves Here? I Added Send effect and made a Send container Including a Simple Reverb. Once I Turn up...
Forum (forum.hise.audio)
-
ok, im so dumb. I had the send container going back into channels 1 and 2 of container 1 and feedbacking on itself. So i added 2 other channels to container 1.
it works now!!
