Table LFO bad modulation range



  • @Christoph-Hart The table LFO doesn't modulate the good frequency in regard to the label when moving a point in a table.
    The Gain doesn't have the good range either (negative is not equal to positive gain modulation), and even when using a sine.

    Also, it would be nice to have a log vertical scale, although it's not a priority

    The example below shows a sweep from 1kHz to 10kHz, which is, in reality, something like 60Hz to 5Khz:

    HiseLfo.gif
    spectrum.gif



  • Another request (yep I got a lot of them at this time 🙂 )
    Would it be possible to have the setting range in the table going permanently up to 20kHz, no matter how the Frequency parameter is set?



  • @Christoph-Hart I found that it's because of the skew factor that is not accessible in a modulator. All is good in scriptnode 😉


Log in to reply
 

11
Online

883
Users

3.2k
Topics

26.8k
Posts