Table LFO bad modulation range

[ustk]

@Christoph-Hart The table LFO doesn't modulate the good frequency in regard to the label when moving a point in a table.
The Gain doesn't have the good range either (negative is not equal to positive gain modulation), and even when using a sine.

Also, it would be nice to have a log vertical scale, although it's not a priority

The example below shows a sweep from 1kHz to 10kHz, which is, in reality, something like 60Hz to 5Khz:

[ustk]

Another request (yep I got a lot of them at this time :) )
Would it be possible to have the setting range in the table going permanently up to 20kHz, no matter how the Frequency parameter is set?

[ustk]

@Christoph-Hart I found that it's because of the skew factor that is not accessible in a modulator. All is good in scriptnode ;)