Temposync display/knob problem.
-
Using the temposync on an LFO is a bit of a mess really.
Say you set it to 1/4 ...then you switch to ms and it goes to 5 hz , (which is quite bit faster to start with ...but that is not the main problem) then you switch back to Temposync and it shows something like 16T ....it still modulates at 1/4 but shows 16T. From now on , if you dont touch the freq it will switch between 5 hz and 16t , while modulating at 1/4.
If you start at 16 , switch to ms , then back to Sync , now it shows 1/2...
Its a mess really.
Maybe this has been discussed , could not find it...but quite unusable at the moment unless someone has a cure ?
-
-
Yes, thought I would make a separate post about this in the hopes that it gets fixed.
-
@lalalandsynth It's not a bug to me because you'll need to calculate it yourself anyway in order to updating the scriptSlider
-
So will scripting correct this ?
-
@lalalandsynth Yes that was the purpose of my link above…
In the sync button CB, calculate the approaching value and update the knob
