Collaborative project!
-
I see, so when I pull it just adds the changes , but not what I have changed .
As in it keep my build folder. Assume it does , want to be sure. -
My mono compatibility test.
https://youtu.be/ywANVcYSndc -
@lalalandsynth Ok I changed the Leslie low end to be 100% mono so we're sure...
-
@ustk ok, there would only be one mic on the low horn.
Working on Top main graphic and Product shots.
Will pull a bit later and test again. -
@lalalandsynth Ok so it's cool
But strange, here it's less obvious, but I'm quite sure it's because of the drawbars patch I have...
Anyway, problem gone ;) -
@lalalandsynth Is it I or the general level is low than yesterday?
The meter was almost hitting the 0dB at full level, now it's like /2 -
@ustk In pro model we can add another lower gui for ..
1.more tweakable reverb.
2.Saturation
3. Mic settings on Leslie.:)
-
@ustk said in Collaborative project!:
@lalalandsynth Is it I or the general level is low than yesterday?
The meter was almost hitting the 0dB at full level, now it's like /2Testing in Hise or DAW ?
Not sure , did not observe the levels . -
@lalalandsynth said in Collaborative project!:
@ustk In pro model we can add another lower gui for ..
1.more tweakable reverb.
2.Saturation
3. Mic settings on Leslie.:)
And even more ;)
Testing in Hise or DAW ?
In hise, I was used to see the meter going further.
Also at full level, I need to push my monitor controller a lot more, above the habitual comfortable level I use.
So I think adding the possibility of pushing the knob to +12dB might be a good solution -
Ok, I am getting this weird thing when starting play.
In the video you can hear it easily when I stop and start play.
Almost hurts my ears .
https://youtu.be/R-g-OK--tiY -
You should add a got ignore file to avoid tracking the build folder.
-
@lalalandsynth Strange, will test that after lunch...
Ok so the last changes I've pushed are:
- Chorus ON/OFF inversion
- Leslie low end is 100% mono
- Level can go up to +12dB
- Preset panel has 2 columns instead of 3
-
@d-healey When I do that it never works if I delete the binary folder and build again...
I might doing something wrong... -
Morning guys!!! 8AM here. reading :)
-
JAMMING !
https://youtu.be/kvsWPFntqSU -
@lalalandsynth Youhou!!!!
-
@lalalandsynth Yeahhhhhhhh :)
-
@hisefilo I forgot, the perc buttons need to be addressed too. The right one is, in fact, a knob, needs to be changed for a button...
So if I understood well, there's no more middle pos right?
I'm on it... -
@ustk Yes, the Perc on off switch engages the whole perc function, then you use the harm switch to select between 2nd and 3rd.
Keyclick will always be engaged .
-
@lalalandsynth @hisefilo Perc buttons sorted and pushed.
KeyClick is always ON, it seems a bit loud to me.
PERC 2nd harmonic seems quiet, but again I don't know how it should be...