Collaborative project!

[ustk]

@lalalandsynth Is it I or the general level is low than yesterday?
The meter was almost hitting the 0dB at full level, now it's like /2

[lalalandsynth]

@ustk In pro model we can add another lower gui for ..

1.more tweakable reverb.
2.Saturation
3. Mic settings on Leslie.

:)

[lalalandsynth]

@ustk said in Collaborative project!:

@lalalandsynth Is it I or the general level is low than yesterday?
The meter was almost hitting the 0dB at full level, now it's like /2

Testing in Hise or DAW ?
Not sure , did not observe the levels .

[ustk]

@lalalandsynth said in Collaborative project!:

@ustk In pro model we can add another lower gui for ..

1.more tweakable reverb.
2.Saturation
3. Mic settings on Leslie.

:)

And even more ;)

Testing in Hise or DAW ?

In hise, I was used to see the meter going further.
Also at full level, I need to push my monitor controller a lot more, above the habitual comfortable level I use.
So I think adding the possibility of pushing the knob to +12dB might be a good solution

[lalalandsynth]

Ok, I am getting this weird thing when starting play.
In the video you can hear it easily when I stop and start play.
Almost hurts my ears .
https://youtu.be/R-g-OK--tiY

[d.healey]

You should add a got ignore file to avoid tracking the build folder.

[ustk]

@lalalandsynth Strange, will test that after lunch...

Ok so the last changes I've pushed are:

• Chorus ON/OFF inversion
• Leslie low end is 100% mono
• Level can go up to +12dB
• Preset panel has 2 columns instead of 3

[ustk]

@d-healey When I do that it never works if I delete the binary folder and build again...
I might doing something wrong...

[hisefilo]

Morning guys!!! 8AM here. reading :)

[lalalandsynth]

JAMMING !
https://youtu.be/kvsWPFntqSU

[ustk]

@lalalandsynth Youhou!!!!

[hisefilo]

@lalalandsynth Yeahhhhhhhh :)

[ustk]

@hisefilo I forgot, the perc buttons need to be addressed too. The right one is, in fact, a knob, needs to be changed for a button...
So if I understood well, there's no more middle pos right?
I'm on it...

[lalalandsynth]

@ustk Yes, the Perc on off switch engages the whole perc function, then you use the harm switch to select between 2nd and 3rd.

Keyclick will always be engaged .

[ustk]

@lalalandsynth @hisefilo Perc buttons sorted and pushed.
KeyClick is always ON, it seems a bit loud to me.
PERC 2nd harmonic seems quiet, but again I don't know how it should be...

[lalalandsynth]

@ustk Agreed , its a bit loud.

[lalalandsynth]

Testing some animation. crap camera movements , just getting a feel for it.
https://youtu.be/IeESg3Ed43g

[hisefilo]

@ustk LOL.... did the same. will discard my local changes heheheh

Perc buttons sorted and pushed.

[lalalandsynth]

@hisefilo Did you see my comments , about panning etc ?

[ustk]

@lalalandsynth @hisefilo Now I removed all the redundant DefaultEnvelope modules in the perc section
Consequently, I adjusted the Keyclick gains, And the PERC level seems better too
I need you to tell guys ;)