How to display a label from a script processor to a label in the main interface. (processor ID doesn't work)

[David Healey]

@Yannrog What does the label show?

[Yannrog]

@David-Healey chord names from a script

[David Healey]

@Yannrog Does the chord detector do anything other than show the names of chords?

[Yannrog]

@David-Healey in the script, it searches for what note beeing pressed, there on init scripts, onNoteon callbacks, onNoteoff callbacks. I started from your example of chord detection to help, it works perfect, however I can't display it in the main interface.

[David Healey]

@Yannrog If all it's doing is showing chord names then it should be part of the interface script rather than a separate midi processor

[Yannrog]

@David-Healey Yes, I tried however.
For some reason it cancel some codes,

and does not work.

[David Healey]

@Yannrog You can't just dump it in to your existing script, you need to write it into your script so it all works as a single unit

[Yannrog]

@David-Healey ok,

Normally it works well,

When I add it to the script, it doesn't know the function “push“ and “indexof“. I am doing a beginner mistake. I am wondering, why it works by itself and when I add it to the new script it doesn't know the functions..

[David Healey]

@Yannrog Unknown function means the thing on the left side of the . is not what you think it is. In this case it means it's not an array.

[Yannrog]

@David-Healey Thank you, I'll check it

[Yannrog]

@David-Healey
Yes it's a problem with the array,

In the chord script (works well by itself), when I delete the "reg keyheld = [ ]" line
It does not work anymore. It acts like when I tried to add it to the main script.

How can I fix the array, because it's a long list of chords

[David Healey]

@Yannrog I'd need to see some code