Forum

    • Register
    • Login
    • Search
    • Categories

    SideChain Gain LFO Bug

    Bug Reports
    2
    3
    95
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Tania Ghosh
      Tania Ghosh last edited by

      Here are the few bugs found in Gain Modulation>LFO Modulator + Table

      • lfo doesn't start exactly at the start of a bar
      • spline's slope sometimes goes into the opposite direction when scrolled than usual
      • start- and end-points of the spline can be set to not be the same which is prone for discontinuities
      • when clicking the start- or end point that can create a new point which can't be deleted anymore then
      • decrease in volume when sidechain dialed in without a way to compensate
      • not a bug but strongly suggested: add a way to retrigger the lfo manually. especially useful for 3/16th rhythms and stuff

      Found these when tried to make SideChain LFO with table.

      Tania Ghosh

      Y 1 Reply Last reply Reply Quote 0
      • Y
        yall @Tania Ghosh last edited by

        @Tania-Ghosh I did one last year and I abandoned the idea of ​​doing it with a gain because the gain itself has a latency. it does not cut clean when you reset, it leaves a little slack. I did it with another volume knob. I'll tell you which one. it worked but was only in sync if the daw project started from the beginning. but what is certain is that to make a "sidechain" avoid the gain modulation of the Gain.

        Tania Ghosh 1 Reply Last reply Reply Quote 2
        • Tania Ghosh
          Tania Ghosh @yall last edited by

          @yall Correct 👍

          Tania Ghosh

          1 Reply Last reply Reply Quote 0
          • First post
            Last post

          9
          Online

          1.1k
          Users

          7.0k
          Topics

          64.6k
          Posts