How to Reset LFO to Start via script?

[CyberGen]

Hi,

I need a way to reset an LFO to the starting point of its oscillation, no matter where in the cycle it currently is. Ideally, I would like to do this via a script or control without relying on IgnoreNoteOn.

I was going to request it as a feature, but I’m wondering if there’s already a way to force it back to its initial phase position. My goal is to achieve a clean LFO reset without affecting the rest of the synth or triggering unwanted sound events.

I had posted about this a long time ago, but I can't find the post now.

Has anyone managed to solve this issue or found a workaround to reliably reset the LFO in this manner?

Any insights or suggestions would be greatly appreciated!

Thanks!

[CyberGen]

@CyberGen fortuitously discovered that setting the ignoreNoteOn to 1 acts as a reset signal. Whenever triggered, the LFO goes back to the start of it's cycle without having to play a note. You might sometimes need to set it back to 0 immediately (depending on what's required of the LFO) but it's a good workaround. :clinking_beer_mugs: