issue with png filmstrips for a simple knob control
-
Hey,
Im having an issue with png filmstrips for a simple knob control.
The PNG is 180 steps and I'm using Figma to make the filmstrips.
Has anyone have any ideas what could be causing this?
Many Thanks
Callum
-
@cadrose Should numstrips be set to 180?
-
@d-healey I originally exported it at 270 which was recommended by the plug-in in digna as a starting point but I ran into the same issue.
Is there a general number of steps that’s ideal in hise?
-
@cadrose said in issue with png filmstrips for a simple knob control:
ideal in hise?
Yes zero, use LAF instead of images if you want the best performance.
If you're going to use images though I don't see a need to use more than 128, and I think that's probably too many in most cases.
Regardless of that, did you try setting the numstrips property of your knob to the number of frames in your image?
-
@cadrose
Ah yes, Ive been dabbling with LAF thanks to your videos. However the learning curve feels very steep for me at this stage.I also tried exporting at 32 steps but I'm getting the same issue just more subtle. the knob still rises upwards.
The settings for the knob maker are:
frame angle: 360
start angle: 225
end angle: 135
frames: 32 -
@d-healey said in issue with png filmstrips for a simple knob control:
did you try setting the numstrips property of your knob to the number of frames in your image?
Also 4518.96 doesn't divide evenly into 32 so that might cause an issue - not sure.
-
@d-healey This was the issue, changed the size of the knob before making the filmstrip and this solved it, thanks!