Play a sample loop until release only, then continue with single playback of sample end portion

[Frankbeat]

You might know this feature from Native Instruments Kontakt…

With until release you can set a sample to play a loop until you give a release trigger. So when you release the key, the current loop portion will play back until its end, then not repeat anymore but continue with what's left from the sample after the loop portion.

Can we please have a feature like this in HISE?

I'd like to build a sound set that is based on very low frequency sine signals – Playing them back in a mix with the given release of the HISE envelope is just fine. But when played back solo, a little click sound becomes audible. That is because the release slope is a logarithmic decay (depicted with the green wave below). My samples contain end portions, that were applied spline shaped fade outs (depicted by the blue wave below)

[d.healey]

@Frankbeat I'd also like an option to play the loop x number of times before just playing the rest of the sample.

[Frankbeat]

@d-healey Number of times… Haven’t thought about that yet. Would be interesting, too, yes!